Boost Your Productivity!Translate documents (Ms-Word, Ms-Excel, ...) faster and better thanks to artificial intelligence!
https://pro.wordscope.com
https://blog. wordscope .com
Fysiologische regio's van luchtstroom
Luchtstroom
Luchtstroom beheersen
Luchtstroom controleren
Momentane luchtstroom
Neerwaartse luchtstroom

Traduction de «luchtstroom » (Néerlandais → Anglais) :

TERMINOLOGIE
voir aussi les traductions en contexte ci-dessous
luchtstroom beheersen | luchtstroom controleren

adjust air flow | air flow adjusting | adjusting flow of air | control air flow




fysiologische regio's van luchtstroom in bovenste luchtwegen

Physiological regions of airflow, upper airway


fysiologische regio's van luchtstroom

Physiological regions of airflow


fysiologische regio's van luchtstroom in onderste luchtwegen

Physiological regions of airflow, lower airway




TRADUCTIONS EN CONTEXTE
vermalen tot stukken van ca. 15 mm, met heet water ontvetten bij een temperatuur van ten minste 70 °C gedurende ten minste 30 minuten, van ten minste 80 °C gedurende 15 minuten of van ten minste 90 °C gedurende ten minste 10 minuten, vervolgens wassen en daarna drogen gedurende ten minste 20 minuten in een hete luchtstroom met een begintemperatuur van ten minste 350 °C of gedurende 15 minuten in een hete luchtstroom met een begintemperatuur van meer dan 700 °C.

crushed to pieces of approximately 15 mm and degreased with hot water at a temperature of minimum 70 °C for at least 30 minutes, minimum 80 C for at least 15 minutes, or minimum 90 °C for at least 10 minutes, and then separated and subsequently washed and dried for at least 20 minutes in a stream of hot air with an initial temperature of minimum 350 °C, or for 15 minutes in a stream of hot air with an initial temperature of more than 700 °C,


Decentraal energie-efficiënt ventilatiesysteem met wisselende luchtstroom en warmteterugwinning

Decentralized energy efficient low-pressure ventilations unit with alternating flow and heat recovery


de luchtstroom rond de inlaat van de bemonsteringsbuis dient onbelemmerd te zijn (binnen een hoek van ten minste 270°), zonder enige verstoring van de luchtstroom in de omgeving van het bemonsteringsapparaat (er moet normaal gesproken enkele meters afstand worden gehouden van gebouwen, balkons, bomen en andere obstakels en monsternemingspunten die representatief zijn voor de luchtkwaliteit aan de rooilijn dienen zich minimaal op een afstand van 0,5 m van het dichtstbijzijnde gebouw te bevinden).

the flow around the inlet sampling probe shall be unrestricted (free in an arc of at least 270°) without any obstructions affecting the airflow in the vicinity of the sampler (normally some metres away from buildings, balconies, trees and other obstacles and at least 0,5 m from the nearest building in the case of sampling points representing air quality at the building line),


de luchtstroom rond de inlaat van de bemonsteringsbuis dient onbelemmerd te zijn (binnen een hoek van ten minste 270°), zonder enige verstoring van de luchtstroom in de omgeving van het bemonsteringsapparaat (er moet normaal gesproken enkele meters afstand worden gehouden van gebouwen, balkons, bomen en andere obstakels en monsternemingspunten die representatief zijn voor de luchtkwaliteit aan de rooilijn dienen zich minimaal op een afstand van 0,5 m van het dichtstbijzijnde gebouw te bevinden);

the flow around the inlet sampling probe shall be unrestricted (free in an arc of at least 270°) without any obstructions affecting the airflow in the vicinity of the sampler (normally some metres away from buildings, balconies, trees and other obstacles and at least 0,5 m from the nearest building in the case of sampling points representing air quality at the building line),


For more results, go to https://pro.wordscope.com to translate your documents with Wordscope Pro!
—vermalen tot stukken van ca. 15 mm, met heet water ontvetten bij een temperatuur van ten minste 70 °C gedurende ten minste 30 minuten, van ten minste 80 °C gedurende 15 minuten of van ten minste 90 °C gedurende ten minste 10 minuten, vervolgens wassen en daarna drogen gedurende ten minste 20 minuten in een hete luchtstroom met een begintemperatuur van ten minste 350 °C of gedurende 15 minuten in een hete luchtstroom met een begintemperatuur van meer dan 700 °C.

—crushed to pieces of approximately 15 mm and degreased with hot water at a temperature of minimum 70 °C for at least 30 minutes, minimum 80 C for at least 15 minutes, or minimum 90 °C for at least 10 minutes, and then separated and subsequently washed and dried for at least 20 minutes in a stream of hot air with an initial temperature of minimum 350 °C, or for 15 minutes in a stream of hot air with an initial temperature of more than 700 °C,


1. De luchtstroom rond de inlaat van de bemonsteringsbuis dient onbelemmerd te zijn (binnen een hoek van ten minste 270°), zonder enige verstoring van de luchtstroom in de omgeving van het bemonsteringsapparaat, d.w.z. op een afstand van gebouwen, balkons, bomen en andere obstakels die meer dan tweemaal zo groot is als het hoogteverschil tussen obstakel en bemonsteringsapparaat.

1. The flow around the inlet sampling probe should be unrestricted (free in an arc of at least 270°) without any obstructions affecting the air flow in the vicinity of the sampler, i.e. away from buildings, balconies, trees and other obstacles by more than twice the height the obstacle protrudes above the sampler.


1. De luchtstroom rond de inlaat van de bemonsteringsbuis dient onbelemmerd te zijn (binnen een hoek van ten minste 270°), zonder enige verstoring van de luchtstroom in de omgeving van het bemonsteringsapparaat, d.w.z. op een afstand van gebouwen, balkons, bomen en andere obstakels die meer dan tweemaal zo groot is als het hoogteverschil tussen obstakel en bemonsteringsapparaat.

1. The flow around the inlet sampling probe should be unrestricted (free in an arc of at least 270°) without any obstructions affecting the air flow in the vicinity of the sampler, i.e. away from buildings, balconies, trees and other obstacles by more than twice the height the obstacle protrudes above the sampler.


3.3.2.Luchtkoeling met een snelheid en richting van de luchtstroom ter simulering van de werkelijke omstandigheden mogen tijdens de verhittingsproeven worden toegepast. De snelheid van de luchtstroom mag daarbij niet hoger zijn dan 10 km/h.

3.3.2.Air cooling at a velocity and air flow direction simulating actual conditions, may be used during the heating runs, the speed of air flow being not greater than 10 km/h.


3.2.3.Luchtkoeling met een snelheid en richting van de luchtstroom ter simulering van de werkelijke omstandigheden mogen tijdens de opwarmproeven worden toegepast. De snelheid van de luchtstroom mag daarbij niet hoger zijn dan 10 km/h.

3.2.3.Air cooling at a velocity and air flow direction simulating actual conditions may be used during the heating runs, the speed of air flow being not greater than 10 km/h.


6.05.8 . Wanneer de noodzakelijke ventilatie niet door een natuurlijke luchtstroom kan worden bewerkstelligd , moet een werktuiglijk aangedreven ventilator , bij voorkeur een afzuigventilator , zijn toegepast , waarvan de motor zich niet in de gas - of luchtstroom mag bevinden .

6.05.8. Where the required ventilation cannot be obtained by natural air flow, a fan must be provided, preferably having an exhausted with its motor clear of the stream of gas of air.




datacenter (28): www.wordscope.be (v4.0.br)

'luchtstroom' ->

Date index: 2021-03-30
w